Ad Type:

For Sale

Used

xti 6000 crown power amp 6,000 watts works 100%

Condition:

Used

Everything included in original box。

This is a 9.5 on a scale from 1-10 Output Power (1kHz Power) (With 0.5% THD):

- 2 ohm Stereo (per channel) (With 1% THD): 3,000 Watts - 4 ohm Stereo (per channel): 2,100 Watts

- 8 ohm Stereo (per channel): 1,200 Watts

- 4 ohm Bridge-Mono (With 1% THD): 6,000 Watts - 8 ohm Bridge-Mono: 4,200 Watts

- Requires 20A AC Power - Sensitivity (volts RMS) for full rated power at 4 ohms: 1.4V - Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz): +0/-1 dB - Signal to Noise Ratio (below rated 1 kHz power at 8 ohms), A-weighted: 100 dB - Damping Factor (8 ohm): 20 Hz to 400 Hz: > 500 - Input Stage: Input is electronically balanced and employs precision 1% resistors - At Idle: Draws no more than 90 watts - Crosstalk (below rated power) 20 Hz to 1 kHz: > 70 dB - Input Impedance (nominal): - 20 kilohms balanced - 10 kilohms unbalanced - Load impedance (note: safe with all types of loads) Stereo: 2-8 ohms, Bridge mono: 4-16 ohms - Voltage Gain (at 1 kHz, 8 ohm rated output): 37.1 dB - Maximum Input Signal: +22 dBu typical - Operating Temperature: 0* C to 40* C at 95% relative humidity (non-condensing) - AC Line Voltage and Frequency Configurations Available (+/- 10%): 100V, 120V, 220-240V 50/60 Hz - Ventilation: Flow-through ventilation from front to back - Cooling: Heat sinks and proportional-speed fan - Dimensions (W x H x D) (behind mounting surface): 19 x 3.5 x 16.2 inches (48.26 x 8.9 x 41.15 cm) Weight: - Net Weight: 24 pounds (10.9 kg) - Shipping Weight: 30 pounds (13.6 kg) Contact Details : yangpengpengg@hotmail.com

Australian Capital Territory, New South Wales, Northern Territory, Queensland, South Australia, Tasmania, Victoria, Western Australia

$ 460.00