Ad Type:

For Sale

Used

Dynakit Mark II Power Amp-FULLY RESTORED NICE CONDITION

Condition: use

Specifications:

Power Output: 50 watts continuous, 100 watts peak.

Intermodulation Distortion: Less than 1% at 50 watts;, less than .5% below 35 watts. These figures apply for any conventional combination of test frequencies.

Frequency Response:

± .5 dB 6 cps to over 60 kc.

± .1 dB 20 cps to 20 kc at any level between 1 milliwatt and 50 watts.

Power Response: 20 cps to 20 kc within 1 dB of 50 watts without exceeding 1% harmonic distortion over this range. Square Wave Response: Essentially undistorted 20 cps to 20 kc on loudspeaker load. Sensitivity: 1.5 volts rms input for 50 watts output. Hum and Noise: 80 dB below rated output. Damping Factor: 15. Output Impedances: 8 and 16 ohms (no restrapping required for changing output impedances) (choice of 4, 8, and 16 ohms also available at extra cost). Tubes: 6CA7, EL-34 (2). (6550s can be substituted in output without wiring changes), 6AN8, 5U4GB. If you have any questions, do not hesitate to contact us at any time。 sclfst85d@hotmail.com

Tasmania

$ 200.00